Rotery selectable battery charger DELTA 10A48V

ELNIX -DELTA-10A48V,Multi-Battery Chargers are designed for use in workshops, garages, battery service stations and retail outlets, where there is a requirement for charging a number of batteries simultaneously.

The Multi-battery Manual controlled charger DELTA-10A48V is to charge from 1 to 4 batteries, in series. Its can adjust current (Amps) using rocker switch in two mode (low High) and visibly shown current level in ammeter.

These chargers are also known as 'taper chargers' since charging current reduces gradually, as the battery gets charged. However they will not shut-off automatically. A voltmeter or hydrometer is required to check the battery condition periodically and switch off the charger, once the batteries are fully charged.

This model operates on single phase 230V 50 Hz. A.C. Mains Supply.

The chargers are fitted with double wound copper wire isolated transformer with high grade lamination. Rectification is done by industrial grade full wave bridge rectifier.

Charge current and voltage control by rotary switches, fine tapping selections from the mains transformer. Protection for the charger is provided by means of circuit breakers on the A.C. and D.C. side.

These chargers are built in aesthetically designed thick sheet metal cabinets with volt meter and ammeter to ensure the battery volt and current level when charging.